Application notes: Original unit may have 3 pin connector for board control of power supply fan. Replacement part operates without this connector.
This power unit has (1) ATX connector, (1) ATX12V connector, (3) peripheral
power connectors, and (1) floppy drive connector.
Please View Picture for Detail
Remote ON/OFF Control: The Power supply shall
accept a logic open collector level which will disable /enable all out put
voltage (excluding +5V standby).
Temperature range: operating 0º ~50ºC, storage-20º ~ +65ºC
Temperature coefficient: 0.01% / 0ºC
Transient response: output voltage recovers in less than 1 ms max. following a 25%load change
16.6ms minimum – at 115V/60Hz.
16.6ms minimum –at 230V50Hz.
Humidity: 5~95% RH
Efficiency: 65% min. 70% typical at full load
Power good signal: turn-on delay 100ms to 500ms
Dielectric withstand: input / output 1800VAC for1 second, input to frame ground 1800VAC for 1 second
+5V output 6.5V
+3.3V output 4.6V
+12V output 15.5V
Dimensions US 4.9" x 3.9" x 2.5"
Safety UL, CSA, CE, NEMKO, CB, TUV
* Note: The product specification and pictures are subject to change without notice.